Silhouette Curio not recognizing registration on laser printer marks

Ursula's Digital Mixed-Media
Silhouette Curio not recognizing registration marks

After spending an entire morning fighting with print and cut on my Silhouette Curio, I FINALLY realized that it was the laser printer I was using. Too shiny! A little sharpie marker coloring over the lines to dull it down and voila! Print and cut is back to working, yay!

You can see the sharpie marker lines are a little squiggly in the picture below, but it still wotked. Also, it’s an old mat so I tape the edges of the paper to keep it more secure.

Hopefully, this post will save you from tearing your hair oit or thowing your Silhouette machine out the window, haha.

Silhouette Curio not recognizing registration on laser printer marks
Silhouette Curio not recognizing registration on laser printer marks

Leave a Reply

two × four =